PTFE Syringe Filters (Halogenated Solvent Safe)

Order Code: C101

Price

(excluding Taxes)

£34.80


Having the right filter for you solutions is essential in order to maintain reliable experimental results and to provide the highest performance from your solutions. The choice of filter for your experiment is crucial as the diameter, pore size, membrane material, and housing are all important. At Ossila we have selected a range of syringe filters which can be used for most applications and are all compatible with our solvent-safe polypropylene syringes.

 Syringe filters




Product List

Product Code C101 C102 C103 C104
Pore Size 0.1μm 0.22μm 0.45μm 1.2μm
Membrane PTFE (Hydrophobic)
Filter Diameter 13 mm
Filtration Area >1.3 cm2
Retained Fluid <100 μl
Pack Size 100 filters
Package Type Low dust polyethylene box

Specifications

Filter Housing Polypropylene / High Density Polyethylene
Inlet Attachment Female Luer lock
Outlet Attachment Male Luer Slip
Maximum Operating Temperature 60 ℃
Sterilization Autoclave at 121 ℃ for 20 minutes

 


Membrane Filtration Overview

Membrane filtration is a method of removing particulates from solution without the need for any heating which is typically used in other processes such as sublimation and distillation. Membrane filtration simply works by restricting the movement of particles above a specific size through a porous material. Typically membrane filtration is separated into several categories dependent upon particle size. These are, particle filtration, microfiltration, ultrafiltration, nanofiltraion, and reverse osmosis. These different categories cover particle sizes ranging from centimeters down to angstroms. Below is an image highlighting the range covered by microfiltration membranes highlighting the types of materials that can be filtered out.

Microfiltration

Membrane filtration is used in a variety of scientific fields including biotechnology, pharmaceuticals, medicine, chemistry, and semiconductor manufacturing. Each field has very different requirements for the filters and the choice of filter type can depend upon the solvent being filtered, the size of particles that need removing, whether the filters need to be sterile, the volume of solution being filtered, and the temperature of your solution. If you are unsure about what particular membrane would best suit your needs please see the following section.

 


Choosing the Correct Filter

At Ossila we currently only sell hydrophobic PTFE membranes, this is due to the wide variety of chemicals that this material is compatible with. PTFE can be used with almost any solvent and due to its low reactivity has low extractables, in addition PTFE has extremely high thermal stability allowing for a wider range of processing temperatures than standard membrane materials. Although PTFE is naturally hydrophobic it is possible to filter aqueous solutions when the membrane is prewetted prior to filtration.

 

Below is a table showing the sizes of solutions suitable for different filter diameters

Diameter Solution Volume
5mm < 1ml
13mm <10 ml
25mm < 50ml

We have found 13 mm diameter filters provide the best combination of filtering capability/capacity with minimum solution loss.

 

The pore size of your filter is dependent upon the material you wish to remove, as the membrane material has a distribution of pore sizes about an average size it is possible that particles bigger than the stated pore size may pass through. We recommend choosing a pore size just below the minimum size of particle you wish to remove.

 

To the best of our knowledge the technical information provided here is accurate. However, Ossila assume no liability for the accuracy of this information. The values provided here are typical at the time of manufacture and may vary over time and from batch to batch.